5/30/2023 0 Comments Cpu q fan control![]() ![]() ![]() With the Hyper 212 EVO 4-pin PWM fan connected to the 4-pin CPU_FAN header (which is PWM) it should not beep and cough up the CPU Fan Error message prompting you to Press F1 to Run Setup at boot. 0303, GPU: EVGA 760 2GB PSU: EVGA 650W GQ Series CPU: Intel i7 950 Motherboard: Asus p6x58d-e BIOS: American Megatrends Inc. I went back into the BIOS and checked if the RPM went down which it did to 600RPM and I was just wondering if I did it all right? I have hardly any knowledge of stuff like this, also should I enable Q-Fan for my 2 Chassis fans aswell? but I only saw 1 in the bios, they're both spinning so I'm not sure what to do. Hi there, So I just installed my Cooler Master Hyper 212 EVO and because I had to remove my CPU out of it's socket to clean it as their was dust around socket, the "New CPU has been detected" which 2 options came up "Config new CPU settings" or "Load/Use old settings"(that's probably not what it said but you get the idea) which I picked the Load existing settings, and I noticed the 212 EVO Fan was a tiny bit loud(Like your GPU Fan at 60% loud) so I checked the Monitor Hardware in the BIOS and yes the 212 EVO was 1600 RPM(Highest it goes for the EU Ver) which I quickly enabled CPU Q-Fan and selected the Standard setting and saved & exit. ![]()
0 Comments
Leave a Reply. |